KhTA EP V4 epoxy chemical anchor — 450 ml cartridge, 2:1 ratio
Khimtrast epoxy anchor in a 450 ml cartridge for M8–M30 studs and rebar starters in concrete; installation at temperatures from 0 °C.

PU varnish is applied to a polymer floor no earlier than 24 h after the floor is laid, in one or two coats, by brush, roller or spray. The clear film gives a gloss of 90–98 %, protects against UV and resists abrasion well — Taber abrasion not more than 20 mg per 1000 revolutions. Foot traffic is allowed after 24 h, impact and vibration loads after 3–5 days; the varnish is also used to protect metal.
| Manufacturer | KHIMTRAST — AO “Khimtrast”, Nizhnekamsk |
|---|---|
| Type | sealers and finish coats |
| Use | warehouses and logistics, retail and public |
| Base | two-component polyurethane varnish (A:B = 100:50 by weight); non-volatiles at least 80 % |
| Colour | clear, gloss (gloss at 60° 90–98 %) |
| Packaging | component A — steel conical pails 10 l – 5 kg and 20 l – 12 kg; component B — cans/canisters 3 l – 2.5 kg and pails/canisters 10 l – 6 kg |
| Application method | airless or air spraying, brush, roller; over a polymer floor no earlier than 24 h after it has been laid; 1–2 coats, recoat interval 24 h |
| Application temperature | +10…+25 °C; relative humidity not more than 65 % |
| Curing | drying to degree 3 — not more than 3 h; foot traffic after 24 h; impact and vibration loads after 3–5 days |
| Key properties | Taber abrasion not more than 20 mg/1000 rev; gloss 90–98 %; direct impact strength (U-2M) at least 30 cm; flexibility not more than 1 mm; hardness (TML, pendulum A) 0.20–0.30; adhesion not more than 1 point; pot life at least 30 min; UV protection |
| Layer thickness | 60–150 µm total dry film (1–2 coats) |
| Consumption | 80–100 g/m² (laboratory figure; actual consumption may be 5–40 % higher) |
| Shelf life | 6 months from the date of production at 0…+25 °C |
| Standards | TU 20.30.12-107-27903090-2023 |
Data from the manufacturer’s technical data sheet. The coating system, number of coats and quantity are selected for your project on request.
Khimtrast epoxy anchor in a 450 ml cartridge for M8–M30 studs and rebar starters in concrete; installation at temperatures from 0 °C.
Two-component polyurethane primer-enamel in RAL colours for concrete floors in car parks, car services, warehouses and workshops, and for wood and metal.
Soft sprayed polyurea for roofs, foundations and vessels without impact loads; flexibility at −30 °C, adhesion to concrete 2.23 MPa.
One-component polyurethane primer for impregnating, hardening and dustproofing concrete and wood before KHIMTRAST polymer coatings.
Two-component epoxy resin for restoring the monolithic integrity of concrete with spalls and cracks; tensile strength at least 10 MPa.
Two-component polyurethane resin for injection waterproofing of expansion and construction joints; elongation at break 60–70%.