Grouts and anchoring

The Grouts and anchoring section brings together materials for filling the space under equipment base plates, grouting joints of precast reinforced concrete and fixing anchor bolts, rebar starters, threaded rods and rails. Grouts go under bridge and column bearings, turbines, generators, compressors, pumps, presses and machine tools and are used in track concrete and for erecting wind turbine towers.

• Cementitious grouts: non-shrink mixes of pourable consistency, high-strength grades up to 110 MPa, steel-fibre, ultra-rapid-hardening and winter grades, mortars for narrow gaps and drill holes.
• Epoxy grouts — two- and three-component systems with mineral filler for equipment with dynamic loads, anchor pockets, base plates and rails.
• Chemical anchors on epoxy and acrylate bases in cartridges for bonding threaded rods and rebar into concrete, stone and brick, frost conditions included.
• Other materials: an acrylic grout and an acrylic polymer concrete with fast strength gain.

Press “Request a price” here or on any product card to get a price and a product selection. Tell us what is being installed or fixed, the gap under the base plate, the loads on the assembly — static, dynamic or vibration — the rod or rebar diameter and the substrate, the installation temperature and when the equipment must start running. We will pick products from the catalogue and prepare an offer.

Grouts and chemical anchors travel from Tashkent across all regions of Uzbekistan and the Republic of Karakalpakstan; buyers in Turkmenistan, Tajikistan and Kyrgyzstan receive shipments in their own countries. The offer specifies delivery terms to your site.