Supply across Uzbekistan and to Kyrgyzstan, Tajikistan and Turkmenistan +998 93 815 00 53 Telegram sale@coatix.uz
Elakor-PU Lyuks Lak-R/UFB Gloss — transparent varnish with UV filter
ELAKOR

Elakor-PU Lyuks Lak-R/UFB Gloss — transparent varnish with UV filter

Sealers and topcoats

The main purpose of this varnish is to shield the underlying epoxy or polyurethane coating from ultraviolet: a UV filter is included in the formulation. At the same time, the topcoat increases the chemical and wear resistance of the floor, protects parquet, wood and plastic, and serves as a transparent impregnation for concrete, stone, brick and tile. The varnish is applied in two coats with a velour roller at +5…+20 °C; full mechanical load is permitted after 7 days, chemical load after 14 days.

Specifications

ManufacturerElakor — OOO “TEOKHIM-PROM”, Moscow Region
Typevarnishes and topcoats
Useproduction workshops, warehouses and logistics, car parks and ramps, retail and public premises, outdoor areas, chemically resistant, decorative
Basetwo-component polyurethane varnish, lightfast, with UV filter
Colourtransparent, colourless; gloss
PackagingComp. “A” + Comp. “B” = Kit: 8 kg + 1 kg = 9 kg; 16 kg + 2 kg = 18 kg
Application methodTopcoat to protect polyurethane and epoxy coatings from ultraviolet and to increase chemical resistance and wear resistance; UV protection of parquet, wood, plastic; transparent impregnations for concrete, stone, brick, tile. “Velour-Wool” roller (5 mm nap), brushes at abutments; 2 coats, rolling in two mutually perpendicular directions. Relative air humidity not more than 80%; surface 3°C above the dew point; surface temperature difference not more than 3°C during application and for a day afterwards; waterproofing against groundwater on the lowest floor.
Application temperaturesurface, air, materials: +5°C…+20°C
Curingdrying to degree 3 at +20°C not more than 10 h; drying of the 1st coat 6-12 hours, but not more than 24 hours; after application at +15…20°C: foot traffic – 3 days, full mechanical load – 7 days, full chemical load – 14 days
Key propertiesA:B ratio 8:1; mix viscosity VZ-4 10-12 s; solids content at least 32%; density 0.92 kg/l; service temperature range from -60°C to +100°C (up to 30 min – up to +150°C); water absorption not more than 0.1%; film tensile strength at least 40 MPa; elongation at least 8%; impact strength at least 100 cm; Shore D at 28 days 70-74; flexibility not more than 1 mm; Taber abrasion CS-10, 1 kg – 5 mg; fire hazard class KM1; chemical resistance: water, salt and alkali solutions of any concentration, acid solutions up to 10-20%, oils and fats of all kinds, organic solvents, petrol, diesel fuel
Consumption2 coats; consumption per coat: to change surface gloss 60-70 g/m², to seal chips, flakes, glitter 70-80 g/m²
Shelf life8 months in the manufacturer's original packaging; store and transport at temperatures from -30°C to +25°C

Data from the manufacturer’s technical data sheet. The coating system, number of coats and quantity are selected for your project on request.

Other materials by ELAKOR