AKVATRON
AKVATRON-1 — thixotropic repair and waterproofing compound
Rapid-hardening thixotropic fibre-reinforced mix for repair and waterproofing of walls and ceilings, joints and utility entries; adhesion from 2.0 MPa.
Price on request
AKVATRON
AKVATRON-8P — hydraulic plug with extended setting time
AKVATRON-8P is chosen when a little more time is needed to seal a leak: setting takes from 30 s to 5 min, and up to 12 min at the customer’s request. The compound, based on high-alumina cement and calcium hydroaluminate, provides watertightness at the level of concrete of at least W16 and a compressive strength of at least 16 MPa. It is used to fill the prepared hole, pressed in for 0.5–1.5 min, and the surface is then treated with AKVATRON-6 mix.
Specifications
| Manufacturer | AKVATRON — OOO “Akvatron-BKhK”, Biysk |
|---|---|
| Type | hydraulic plugs |
| Use | leak repair, foundations and basements, tanks and pools, tunnels and metro |
| Base | based on high-alumina cement and calcium hydroaluminate with special activating chemical additives |
| Application method | as for AKVATRON-8: fill the hole and press for 0.5–1.5 min, remove the excess, then treat the surface with AKVATRON-6 mix |
| Curing | setting from 30 s to 5 min (up to 12 min at the customer's request) |
| Key properties | watertightness corresponds to a concrete grade of at least W16; compressive strength at least 16 MPa (160 kgf/cm²); linear expansion at least 0.01 % |
| Shelf life | 18 months |
| Standards | TU 5745-054-07508003-2003 |
Data from the manufacturer’s technical data sheet. The coating system, number of coats and quantity are selected for your project on request.
Other materials by AKVATRON
AKVATRON
AKVATRON-8 — hydraulic plug for stopping active leaks
Rapid-setting hydraulic plug for stopping active leaks in cracks and joints; sets in 30 s – 3 min and works under water.
Price on request
AKVATRON
AKVATRON-3 — repair and waterproofing compound, grades L and T
Non-shrink repair mix in two grades, pourable and thixotropic, for bridge slabs, floor slabs, foundations, pools and tanks.
Price on request
AKVATRON
AKVATRON-12 — waterproofing admixture for concrete mix
Crystal-forming admixture for primary waterproofing of cast-in-place concrete and precast units; raises watertightness by at least 2 steps.
Price on request
AKVATRON
AKVATRON-6 — penetrating waterproofing for concrete
Penetrating cementitious mix for concrete in foundations, tanks, tunnels and dams; raises the watertightness grade by 6–8 steps.
Price on request
AKVATRON
AKVATRON-6Sh Shovny — penetrating mix for sealing joints and cracks
One-component joint mix combining mastic elasticity with penetrating waterproofing properties for joints and cracks under cyclic deformation.
Price on request