The heavy-duty PLASTGUARD 900 is intended for areas with service loads where the waterproofing of foundations or roofs needs to be protected. The high-density polyethylene sheet with studs shaped as truncated cones withstands a compression of 560 kPa, and maximum tensile force is 470 N/50 mm along the roll. Like other PLASTGUARD membranes, it is a protective drainage layer, not stand-alone waterproofing. Flexibility is retained down to −50 °C; rolls — 10 or 20 m with a width of 2 m.
| Manufacturer | PENOPLEX (PLASTFOIL, PLASTGUARD) — OOO “PENOPLEX SPb” |
|---|---|
| Type | waterproofing material |
| Use | foundations and basements, roofs |
| Base | profiled membrane of high-density polyethylene (HDPE) with studs shaped as truncated cones |
| Packaging | rolls 10 or 20 × 2 m |
| Application method | horizontally — loose laying; vertically — mechanical fastening along the top edge above the waterproofing level (aluminium clamping bars, Ø50 mm washers, screws and PROPLUG dowels, 200 mm spacing); overlap 150–200 mm, PLASTGUARD joining tapes if necessary |
| Key properties | mass 900 g/m²; compressive strength 560 kPa; base thickness 0.9 mm; maximum tensile force 470/450 N/50 mm (lengthwise/crosswise); cone stud height 8 mm; elongation at maximum force at least 30%; flexibility not higher than −50 °C; dimensional change at 80 °C over 6 h not more than 2%; water absorption not more than 1%; watertightness at 0.001 MPa for 24 h — no traces of water penetration; conventional durability at least 100 years; G4 V3 RP4 |
| Layer thickness | base 0.9 mm, stud 8 mm |
| Shelf life | 2 years from the date of manufacture; on pallets, vertically, in an enclosed room in a single tier, not closer than 1 m to heating appliances; under a canopy for up to 30 days |
| Standards | TU 23.99.12-032-54349294-2023; GOST R 70434 |
Data from the manufacturer’s technical data sheet. The coating system, number of coats and quantity are selected for your project on request.
Unreinforced PVC membrane with a signal layer for foundations, tunnels, car parks and inverted roofs; watertight at 300 kPa for 24 h.
Economy membrane to protect waterproofing and thermal insulation of foundations, ballasted roofs and slabs from capillary moisture; compressive strength 180 kPa.
Profiled polyethylene membrane for protecting foundation waterproofing and distributing load on the base; compressive strength 280 kPa.
Membrane with geotextile for the drainage layer of trafficked roofs and buried structures; compressive strength 630 kPa.
Roofing PVC membrane for mechanically fastened and ballasted roofs, compatible with bitumen; flexibility retained down to −30 °C.
PVC membrane resistant to aggressive media for waste landfills, agricultural lagoons and process liquid storage; change in properties max. 10%.
