Supply across Uzbekistan and to Kyrgyzstan, Tajikistan and Turkmenistan +998 93 815 00 53 Telegram sale@coatix.uz
LEVL Coat 218 — high-gloss epoxy primer-enamel for floors
LEVL (INGRI)

LEVL Coat 218 — high-gloss epoxy primer-enamel for floors

Epoxy floors

LEVL Coat 218 high-gloss epoxy enamel is intended for floors with sanitary and hygiene requirements in the food, pharmaceutical and chemical industries, healthcare and education. The coating is thin-layer: it does not level the substrate, but it bridges fine cracks and can be applied in self-priming mode. It is applied with a velour roller or brush in two coats; the compound is also suitable for covered unheated premises and car parks. Taber abrasion is up to 65 mg, service from −25 to +60 °C.

Specifications

ManufacturerLEVL (INGRI) — OOO “Ingri”, Saint Petersburg
Typeepoxy floors
Useproduction workshops, food and pharmaceutical, retail and public buildings, warehouses and logistics, car parks and ramps, decorative
Baseepoxy resin + cycloaliphatic hardener
ColourRAL colours; smooth-textured high-gloss finish
Packaging20 kg kits (A and B in two containers); A : B = 5 : 1 (by weight)
Application methodthin-layer protective, decorative and wear-resistant floor paint (does not level the substrate) where sanitary and hygiene requirements apply; over LEVL Coat 101/104 Rapid (textured) or 108/118 (smooth) primer, or self-priming with 218 (0.2 kg/m²); velour roller or brush, 2 coats; possible in covered unheated premises and car parks
Application temperatureair +10…+30 °C (recommended +17…+23 °C); substrate +10…+30 °C (recommended +17…+25 °C); material +15…+25 °C; air humidity up to 80 %; substrate moisture no more than 5 % by weight; 3 °C above the dew point
Curinglight loads: +10 °C 32 h, +20 °C 16 h, +30 °C 12 h; foot traffic 6 / 3 / 2 days; full strength gain 10 / 7 / 5 days; next coat after 24–48 h at 20 °C; drying to degree 3 no more than 8 h
Key propertiesTaber abrasion (CS10 / 1000 g / 1000 rev.) no more than 65 mg; cross-cut adhesion no more than grade 1; density 1.13 ± 0.05 g/cm³; non-volatile content at least 74 %; bridges fine cracks; pot life at +23 °C at least 60 min; service temperature from −25 to +60 °C
Consumption150–200 g/m² per coat; 2 coats: 0.3–0.4 kg/m² (finish in the system 0.4 kg/m²; self-priming 0.2 kg/m²; 3 coats permitted when self-priming)
Shelf life12 months from the date of manufacture; storage at +5…+25 °C
StandardsTU 20.30.12-069-94613022-2019; works per SP 29.13330.2011 and SP 71.13330.2017 (Table 8.12); test methods GOST 31992.1, GOST R 31939, GOST 19007, GOST 31149

Data from the manufacturer’s technical data sheet. The coating system, number of coats and quantity are selected for your project on request.

Other materials by LEVL (INGRI)