Supply across Uzbekistan and to Kyrgyzstan, Tajikistan and Turkmenistan +998 93 815 00 53 Telegram sale@coatix.uz
Elakor-PTs T4 SK PROF — universal polyurethane-cement compound
ELAKOR

Elakor-PTs T4 SK PROF — universal polyurethane-cement compound

Polyurethane-cement floors

This compound of the professional line is used in two ways: as a paint-on coating or as a sand-filled textured coating whose roughness can be adjusted. The coating is used indoors, under a canopy and outdoors, and withstands from −30 to +70 °C continuously and up to 150 °C short-term. Compressive strength is at least 54 MPa, flexural strength at least 23 MPa, Taber abrasion not more than 16 mg, fire hazard class KM2.

Specifications

ManufacturerElakor — OOO “TEOKHIM-PROM”, Moscow Region
Typepolyurethane-cement floors
Useproduction workshops, food and pharmaceutical, chemically resistant, outdoor areas
Baseuniversal polyurethane-cement three-component compound for paint-on and filled coatings
Colourgrey, light grey, beige, brown, yellow, blue, green, black; semi-matt/matt finish
PackagingComp. “A” 9 kg + Comp. “B” 6.5 kg + Comp. “C” 14.5 kg = Kit 30 kg
Application methodPaint-on and filled (textured, with sand; adjustable roughness) PTs coatings. Substrate: concrete, concrete and sand-concrete screeds not lower than M350 (B25), cured for at least 28 days; surface moisture is not limited (no puddles); relative air humidity and dew point are not limited
Application temperatureair, surface: optimum +17…+23°C; permissible +10…+30°C; material temperature +18…+22°C
Curingpot life on the surface at (20±2)°C at least 15 min; at (20±2)°C, relative air humidity 70%: foot traffic – 24 h, full mechanical load – 7 days, full chemical load – 14 days
Key propertiesA:B:C ratio by weight 9.0 : 6.5 : 14.5; density 1.49±0.02 kg/l; adhesion (GOST 28574-2014) to concrete B25 > 2.5 MPa, to concrete B40 > 4.0 MPa (failure in concrete); compressive strength (28 days) at least 54 MPa; flexural at least 23 MPa; tensile at least 12 MPa; Shore D hardness 80-85; impact strength U-2M 100 cm; Taber abrasion CS-10, 1000 g, 14 days, not more than 16 mg; service temperature -30°C…+70°C continuous, short-term for up to 2 h up to 150°C; fire hazard class KM2 (V2, D1, T1, RP1); chemical resistance: water, salt and alkali solutions of any concentration, acid solutions up to 10-20%, oils and fats of all kinds, organic solvents, petrol, diesel fuel
Layer thicknesspaint-on coatings 0.5-0.8 mm; filled textured coatings 1.0-3.5 mm
Shelf lifestore and transport at temperatures from +5° to +25°C
StandardsCertificate of conformity (fire safety) “Elakor-PTs”, class KM2; Certificate of conformity “Elakor-PTs”

Data from the manufacturer’s technical data sheet. The coating system, number of coats and quantity are selected for your project on request.

Other materials by ELAKOR