The heavy-duty PLASTGUARD 900 is intended for areas with service loads where the waterproofing of foundations or roofs needs to be protected. The high-density polyethylene sheet with studs shaped as truncated cones withstands a compression of 560 kPa, and maximum tensile force is 470 N/50 mm along the roll. Like other PLASTGUARD membranes, it is a protective drainage layer, not stand-alone waterproofing. Flexibility is retained down to −50 °C; rolls — 10 or 20 m with a width of 2 m.
| Manufacturer | PENOPLEX (PLASTFOIL, PLASTGUARD) — OOO “PENOPLEX SPb” |
|---|---|
| Type | waterproofing material |
| Use | foundations and basements, roofs |
| Base | profiled membrane of high-density polyethylene (HDPE) with studs shaped as truncated cones |
| Packaging | rolls 10 or 20 × 2 m |
| Application method | horizontally — loose laying; vertically — mechanical fastening along the top edge above the waterproofing level (aluminium clamping bars, Ø50 mm washers, screws and PROPLUG dowels, 200 mm spacing); overlap 150–200 mm, PLASTGUARD joining tapes if necessary |
| Key properties | mass 900 g/m²; compressive strength 560 kPa; base thickness 0.9 mm; maximum tensile force 470/450 N/50 mm (lengthwise/crosswise); cone stud height 8 mm; elongation at maximum force at least 30%; flexibility not higher than −50 °C; dimensional change at 80 °C over 6 h not more than 2%; water absorption not more than 1%; watertightness at 0.001 MPa for 24 h — no traces of water penetration; conventional durability at least 100 years; G4 V3 RP4 |
| Layer thickness | base 0.9 mm, stud 8 mm |
| Shelf life | 2 years from the date of manufacture; on pallets, vertically, in an enclosed room in a single tier, not closer than 1 m to heating appliances; under a canopy for up to 30 days |
| Standards | TU 23.99.12-032-54349294-2023; GOST R 70434 |
Data from the manufacturer’s technical data sheet. The coating system, number of coats and quantity are selected for your project on request.
Economy membrane to protect waterproofing and thermal insulation of foundations, ballasted roofs and slabs from capillary moisture; compressive strength 180 kPa.
Membrane with geotextile for the drainage layer of trafficked roofs and buried structures; compressive strength 630 kPa.
Profiled membrane with thermally bonded geotextile for wall drainage and protection of waterproofing; compressive strength 350 kPa.
Profiled polyethylene membrane for protecting foundation waterproofing and distributing load on the base; compressive strength 280 kPa.
Profiled high-density polyethylene membrane for protecting waterproofing and thermal insulation of foundations; compressive strength 200 kPa.
Reinforced PVC membrane for winter installation of flat roofs: laying at air temperatures not below −20 °C, foldability down to −40 °C.
