PLAMCOR-602 thermal insulation layer for indoor fire protection (VMP)
One-pack syntactic foam on acrylic and chlorinated resins — a thermal insulation layer under PLAMCOR-2 for steel indoors.

PLAMCOR-4 belongs to structural fire protection: it is a dry mix based on Portland cement, expanded vermiculite and fibrous fillers, which is mixed with water and applied with SO-150-type plastering machines. The material is non-combustible and intended for heated and unheated premises with non-aggressive and slightly aggressive environments. An enamel is applied on top for decorative appearance and resistance to aggressive vapours and gases. Service life is at least 40 years in placement categories 3–4.
| Manufacturer | VMP — AO “NPKh VMP”, Yekaterinburg |
|---|---|
| Application | steel structures |
| Service conditions | inside heated and unheated premises with non-aggressive and slightly aggressive environments, relative humidity ≤ 75 % |
| Base | dry mix based on Portland cement, expanded vermiculite and fibrous fillers; mixed with water |
| Colour | grey |
| Packaging | paper bags |
| Application method | mechanised, with SO-150-type plastering machines; mesh reinforcement (mesh size up to 60 mm) under vibration and in seismic conditions |
| Application temperature | from +5 to +35 °C, relative humidity ≤ 75 %; for 10 days after application — not below +5 °C |
| Drying | interval between coats — at least 12 h; full curing — at least 28 days; pot life of the mortar — 60 min |
| Compatible primers and topcoats | an enamel is required for decorative appearance and resistance to aggressive vapours/gases: VINIKOR-62, POLITON-UR, POLITON-UR (UV), POLITON-KhV, EVOPOL-12; primers IZOLEP-primer, IZOLEP-mastic, VINIKOR-061, EVOPOL-12, GF-021 |
| Shelf life | 18 months |
| Standards | TU 23.64.10-105-12288779-2021 (replacing TU 5767-105-12288779-2015); TR EAEU 043/2017; GOST 15150; GOST 5802; GOST 23732; GOST 12.3.002-2014 |
Data from the manufacturer’s technical data sheet. The coating system, number of coats and quantity are selected for your project on request.
One-pack syntactic foam on acrylic and chlorinated resins — a thermal insulation layer under PLAMCOR-2 for steel indoors.
Surface-tolerant epoxy primer for ships and hydraulic structures; over steel, non-ferrous metals, fibreglass and concrete.
Silver moisture-curing finish over TSINOTAN, TSINEP and TSVES zinc primers for bridges, oil and gas and power, heat resistance 150 °C.
Modified acrylate primer-enamel for metal and concrete without a separate primer, applied in frost down to −25 °C, RAL colours.
Epoxy intumescent coating that protects steel and reinforced concrete structures in the open atmosphere against fire and corrosion.
Matt enamel for the concrete of bridges and industrial structures, resistant to ultraviolet and abrasion; colours to the RAL catalogue.