CarbonWrap® Putty S two-component epoxy putty — summer version from +10 °C
Epoxy putty for levelling the substrate and repairing small defects and cracks before installing CarbonWrap at temperatures from +10 °C.
CarbonWrap Tape 530/300 is a high-density unidirectional tape on 24K carbon yarn, produced in 50 m rolls 300 mm wide. For high-density tapes the CarbonWrap system provides CarbonWrap Resin 530+ saturating resin, which is used to impregnate the tape and bond it to the substrate. The tensile strength of the fibre is more than 4.5 GPa, the modulus of elasticity more than 230 GPa and the elongation at break more than 1.5 %; the shelf life is 3 years from the date of manufacture.
| Manufacturer | CarbonWrap — OOO “Nanotekhnologicheskiy tsentr kompozitov”, Moscow |
|---|---|
| Type | composite strengthening |
| Use | columns and beams |
| Base | unidirectional tape of high-strength carbon fibres (fibre direction 0°); weft — hot-melt adhesive thread; warp — 24K carbon yarn |
| Packaging | roll of 50 m, width 300 mm, 1 roll per cardboard box; sold by the roll |
| Application method | cutting to the design bonding layout on a clean, flat surface covered with protective film; cut with scissors or a sharp knife, wearing protective gloves; keep free of sand, dust, water, oils and solvents; do not fold the tape (the fibres break at the fold), it may be rolled up for transport; prevent splitting into strands and damage to the fibre; impregnation and bonding with CarbonWrap Resin epoxy saturating resin; for high-density tapes — CarbonWrap Resin 530+ saturating resin |
| Key properties | fibre direction 0°; warp yarn count 32 ± 1 yarns per 10 cm (24K); weft yarn count 10 ± 1 yarns per 10 cm; fibre tensile strength > 4.5 GPa; fibre tensile modulus > 230 GPa; fibre elongation at break > 1.5 % |
| Shelf life | 3 years from the date of manufacture; after that — use after repeat tests for compliance with the TU |
| Standards | TU 23.99.14-041-38276489-2017 (identical to 1916-041-38276489-2017) |
Data from the manufacturer’s technical data sheet. The coating system, number of coats and quantity are selected for your project on request.
Epoxy putty for levelling the substrate and repairing small defects and cracks before installing CarbonWrap at temperatures from +10 °C.
Epoxy saturating resin for high-density carbon materials, for hand and machine impregnation; the “winter” version works from +10 °C.
Epoxy adhesive paste for bonding CFRP laminates and steel plates, levelling the substrate and repairing cracks; 30 kg kit.
Unidirectional carbon tape on 24K yarn for strengthening slabs, bridge span beams, columns and pylons; width 150, 300 or 600 mm.
Thixotropic fibre-reinforced cement mix for restoring spalls, potholes and cracks in concrete, including under CarbonWrap Grid.
Unidirectional carbon tape for the CarbonWrap external reinforcement system, in rolls 150, 300 and 600 mm wide; fibre strength over 4.9 GPa.