The one-component primer based on a polyurethane prepolymer cures with air humidity. FP840 is used in two ways: as a primer under polymer coatings and as a stand-alone hardening impregnation applied in several coats to a gloss. It can be applied at air temperatures down to −10 °C if the substrate is warmed to at least +10 °C. Shore D hardness 70–72, water absorption no more than 0.1%, service from −30 to +60 °C, class KM1. Foot traffic is possible after one day.
| Manufacturer | INDASTRO — OOO “Sedrus” |
|---|---|
| Type | floor primers |
| Use | production workshops, warehouses and logistics |
| Base | polyurethane prepolymer in an organic solvent; cures with air humidity |
| Colour | clear amber-coloured liquid |
| Packaging | 24 kg metal pails, 18 per pallet |
| Application method | brush, velour roller; primer under polymer coatings or stand-alone hardening impregnation (2-3 coats to a gloss); drying between coats 3-8 h |
| Application temperature | air -10…+30 °C; substrate +10…+25 °C; air humidity no more than 80%, substrate moisture no more than 4% |
| Curing | walking after 1 day; full load after 3 days; drying to degree 3 at +20 °C no more than 6-8 hours |
| Key properties | Adhesion to concrete at least 2.5 MPa; Shore D hardness (28 days) 70-72; Taber abrasion (CS-10, 1 kg) 5.5 mg; water absorption no more than 0.1%; solids content at least 50%; service from -30 °C to +60 °C (up to +90 °C for up to 30 min); fire hazard class KM1 |
| Consumption | 100-200 g/m2 (per the table); 150-250 g/m² per coat (in the application section) |
| Shelf life | 12 months; storage +5…+25 °C |
| Standards | manufacturer's TU; KM1 (G1, V1); SP 29.13330.2011, SP 71.13330.2017 |
Data from the manufacturer’s technical data sheet. The coating system, number of coats and quantity are selected for your project on request.
Thixotropic R4 mortar for repairing B30–B40 concrete and reinforced concrete structures, including walls and ceilings; compressive strength at 28 days from 45 MPa.
Fibre-reinforced finishing mortar for fine finishing of concrete structures in winter at temperatures from −10 to +10 °C; compressive strength 40 MPa at 28 days.
Cementitious compound for protecting reinforcement against corrosion and forming a bonding layer in concrete repair; bond to the substrate from 2.0 MPa.
Thixotropic R4 mortar with 1.25 mm aggregate for structural repair of concrete; 20 MPa in 24 hours and 45 MPa in 28 days.
Finishing repair mortar with fibre and sand up to 0.63 mm for load-bearing, bridge and treatment structures; compressive strength from 20 MPa after one day.
Fibre-reinforced mortar with sand up to 0.63 mm for repair and finishing of concrete structures of bridges, treatment plants and underground facilities; W12.
