LEVL JOINT PANEL 130 — composite panel for joints in industrial floors
Polymer joint panel with elastic polyurethane infill for constructing and repairing thermal and shrinkage joints in warehouses and workshops.

Fresh concrete aged from 7 days or a damp substrate can be primed with LEVL Coat 106M water-based epoxy compound. It serves as a temporary moisture barrier under epoxy, polyurethane and acrylic coatings and contains no organic solvents. Two or more coats are applied by roller or brush without dilution; the next coat after 12–24 hours, tools are washed with water. Adhesion to concrete is over 4.0 MPa; without waterproofing of the substrate, delamination of the coating is possible, which should be taken into account at the design stage.
| Manufacturer | LEVL (INGRI) — OOO “Ingri”, Saint Petersburg |
|---|---|
| Type | floor primers |
| Base | two-component water-based epoxy primer; no organic solvents |
| Colour | comp. A: white liquid; comp. B: light yellow liquid |
| Packaging | 10 kg (components A and B in two separate containers); A : B = 2 : 1 (by weight) |
| Application method | primer for fresh (from 7 days) or damp concrete substrates, temporary moisture barrier under epoxy, polyurethane and acrylic coatings; velour roller, brush, 2 or more coats; next coat after 12–24 h; must not be diluted; tools are cleaned with water |
| Application temperature | air and substrate +10…+30 °C; air humidity no more than 80 %; substrate visually dry (no darkening) |
| Curing | walkable: +10 °C 12 h, +20 °C 7 h, +30 °C 5 h; light loads 7 / 5 / 3 days; full loads 12 / 7 / 5 days |
| Key properties | Adhesion to concrete > 4.0 MPa (failure in the concrete); non-volatile content 63 ± 2 %; mix density 1.05 g/cm³; pot life +10 °C 40 min, +20 °C 30 min, +30 °C 20 min |
| Consumption | 100–250 g/m² per coat |
| Shelf life | 6 months from the date of manufacture; storage at +5…+25 °C |
| Standards | TU 2316-003-94613022-06; works per SP 29.13330.2011, SNiP 3.04.01-87; test methods GOST 28513-90, GOST 25271-93, GOST 28574-90, GOST R 52487-2005 |
Data from the manufacturer’s technical data sheet. The coating system, number of coats and quantity are selected for your project on request.
Polymer joint panel with elastic polyurethane infill for constructing and repairing thermal and shrinkage joints in warehouses and workshops.
Film-forming curing compound for concrete and toppings based on an aqueous styrene-acrylic copolymer, without organic solvent.
Polyethylene fibres that make carboacrylates, adhesives, sealants and coatings thixotropic; chemically resistant, asbestos-free additive.
Epoxy primer with accelerated curing under LEVL floors: foot traffic after 6 hours, full strength in about 12 hours at +20 °C.
Thin-layer PU-cement coating and sand seal coat in PoliCem systems for food and chemical workshops; Taber abrasion up to 60 mg.
Topping with quartz and corundum aggregate for workshops, warehouses and car parks under very significant loads; abrasion (wear) no more than 0.15 g/cm².