Supply across Uzbekistan and to Kyrgyzstan, Tajikistan and Turkmenistan +998 93 815 00 53 Telegram sale@coatix.uz
Elakor-ED Grunt-2K/100 — low-viscosity solvent-free epoxy primer
ELAKOR

Elakor-ED Grunt-2K/100 — low-viscosity solvent-free epoxy primer

Floor primers

This low-viscosity solvent-free epoxy compound primes concrete, tile, asphalt concrete, slate, brick, stone and metal under paint-on, quartz-filled and self-levelling epoxy floors. It is also used as a stand-alone transparent impregnation for concrete or as a filler mixed with quartz. Adhesive strength to M750 concrete is 6.4 MPa, compressive strength 96 MPa, Shore D hardness 80–85; apply at air and substrate temperatures from +5 to +20 °C.

Specifications

ManufacturerElakor — OOO “TEOKHIM-PROM”, Moscow Region
Typefloor primers
Useproduction workshops, warehouses and logistics, car parks and ramps, retail and public premises, wet rooms
Basetwo-component low-viscosity solvent-free epoxy primer; composition: epoxy resin, hardener, functional additives
Packaging“A” + “B” = Kit 20 kg + 9 kg = 29 kg
Application methodPriming of concrete and mineral substrates (tile, asphalt concrete, slate, brick, stone) as well as metal under epoxy floors of all types (paint-on, quartz-filled, self-levelling); stand-alone transparent epoxy impregnation of concrete; filling with quartz. Surface moisture not more than 4 wt%, relative air humidity not more than 80%, surface temperature 3°C above the dew point; on the lowest floors – waterproofing against rising damp; preparation – removal of laitance/weak layer by grinding or shot blasting. Rollers, brushes, flat metal or rubber trowel.
Application temperatureair and surface: from +5°C to +20°C; material: from +15°C to +20°C
Curingpot life at 20.0±2.0 °C at least 30 min; drying to degree 3 not more than 8 h
Key propertiesA:B ratio by weight 100:45 (may vary); non-volatiles 100%; mix density 1.05 kg/l; service temperature range -30..+80°C; adhesive strength to concrete M750 (B55) 6.4 MPa (failure in concrete); adhesion to glass not more than 1 point; film resistance to static exposure to water at least 48 h, xylene at least 48 h, butyl acetate at least 24 h (at (20±2)°C); compressive strength 96 MPa; tensile strength 26 MPa; elongation 4%; impact strength U-2M 60 cm; flexibility (bend test) not more than 10 mm; Shore D hardness (28 days) 80-85; chemical resistance: water, salt and alkali solutions of any concentration, acid solutions up to 10-20%, oils and fats of all kinds, organic solvents, petrol, diesel fuel
Consumptiondepends on porosity
Shelf lifestore and transport at temperatures from 0° to +25°C
StandardsFire safety certificate “Elakor-ED”; ROSTEST letter “Elakor-ED”

Data from the manufacturer’s technical data sheet. The coating system, number of coats and quantity are selected for your project on request.

Other materials by ELAKOR