AkvaVIS P1K — one-component polyurethane injection foam
Fast-curing one-component foam for eliminating water inflow, sealing joints and filling voids behind tunnel linings; reaction with water in 60 s.
AkvaVIS S404 is a two-component polyurethane resin used to consolidate soils and rocks, seal off groundwater, strengthen foundations and carry out work using the “wall in soil” (diaphragm wall) technique. The material is produced in versions B, S and M with different reaction times: without water the reaction starts after 15 s, 90–150 s and 40 min respectively. The resin is injected with a pump through metal packers with mixing in a static mixer; it does not shrink, foams up to 1:10 and is suitable for cracks with an opening of more than 0.25 mm.
| Manufacturer | AkvaVIS — OOO “GELIOS” |
|---|---|
| Type | other concrete repair materials |
| Use | tunnels and metro, hydraulic structures and dams |
| Base | two-component polyurethane resin for consolidating soils and rocks; versions B, S, M (different reaction times) |
| Application method | soil analysis before the work; one-component piston pump with a 1 : 1 ratio, mixing in a static mixer gun; metal packers; keep at +17…+22 °C for 24 hours beforehand; A : B ratio 1 : 1.2 by weight (1 : 1 by volume) |
| Curing | start of reaction without water: B — 15 s, S — 90–150 s, M — 40 min; gelation (20 °C): 40 s / 0.5–1 min / 40–120 min; curing: 3 / 5 / 240 min |
| Key properties | viscosity (25 °C): component A 500, B 200 mPa·s; density A 1.04±0.03, B 1.23±0.03 g/cm3; foaming ratio up to 1 : 10 (4–10 times in free space), without water — 2 times; no shrinkage; for cracks with an opening of more than 0.25 mm |
| Standards | STO 69626291-001-2012 |
Data from the manufacturer’s technical data sheet. The coating system, number of coats and quantity are selected for your project on request.
Fast-curing one-component foam for eliminating water inflow, sealing joints and filling voids behind tunnel linings; reaction with water in 60 s.
Low-viscosity resin for sealing dry and damp cracks and joints in reinforced concrete and cut-off waterproofing of masonry; penetrates cracks from 0.2 mm.
Three-component accelerated foam for emergency stopping of active water inflow through joints, cracks and voids; with water the reaction starts after 20 s.
Elastic hydroactive foam with activator for sealing joints, cracks and voids under dynamic loads; reacts with alkaline water up to pH 13.
Polyurethane compound that works as a foam for stopping water inflow and, with component A, as an elastic resin; expands 10–15 times with water.
Elastic resin for injecting cracks, joints and penetrations in reinforced concrete, including through injection hoses; tensile strength at break 11 MPa.