Monopol TOP 100 — quartz dry-shake topping for concrete floors
Quartz hardening mix for concrete floors with light loads in workshops, warehouses, car parks and outdoor areas; strength from 70 MPa.

The two-component PU 18W varnish on a water-based polyurethane dispersion provides matt colourless protection and does not yellow under ultraviolet light. The manufacturer recommends it as a finish over Policrete 150, 203 and 306 polyurethane-cement floors and in the TERRAZZO system; it is also suitable for epoxy, polyurethane, polymer-cement and concrete coatings. It is applied with a velour roller in two coats, dries in 60 minutes at +20 °C, and full load is allowed no earlier than after 2 days. Taber abrasion is 28 mg.
| Manufacturer | Monopol — OOO “TEKHBETON” |
|---|---|
| Type | varnishes and finishing coats |
| Use | decorative, chemically resistant |
| Base | two-component polyurethane varnish based on a water dispersion; solvent-free |
| Colour | clear/colourless, matt |
| Application method | matt protective varnish over epoxy, polyurethane, polyurethane-cement, polymer-cement and concrete floors; velour roller, 2 coats |
| Curing | full service loads no earlier than 2 days |
| Key properties | Does not yellow under UV; chemical resistance to water, dilute and medium-concentration alkalis and acids, oils, petrol, solvents |
| Consumption | coat 1 0.05–0.08 kg/m² (depending on substrate condition), coat 2 0.05 kg/m² |
| Shelf life | 12 months from the date of manufacture; store at a temperature not below +5 °C and not above +30 °C; do not freeze |
Data from the manufacturer’s technical data sheet. The coating system, number of coats and quantity are selected for your project on request.
Quartz hardening mix for concrete floors with light loads in workshops, warehouses, car parks and outdoor areas; strength from 70 MPa.
Clear solvent-free epoxy primer for self-levelling polymer floors; with quartz sand it is used to repair cracks and spalls in concrete.
Gloss epoxy enamel for dustproofing and protecting concrete floors in workshops, warehouses and car parks; full loads after 72 hours.
High-strength polymer-cement finishing floor and repair compound for concrete floors; compressive strength from 55 MPa, walkable after 6 hours.
Conductive water-based epoxy primer for Policrete 306 AS antistatic floors in cleanrooms, pharmaceuticals and chemicals; below 10⁶ Ω.
Thin-layer polyurethane-cement coating for food and wet workshops, garages and warehouses; slip resistance R10, class KM1.