CarbonWrap® Putty S two-component epoxy putty — summer version from +10 °C
Epoxy putty for levelling the substrate and repairing small defects and cracks before installing CarbonWrap at temperatures from +10 °C.

CarbonWrap Lamel T-50 laminates are made by polyurethane pultrusion: high-strength carbon fibres, more than 65 % by volume, are bound by a polyurethane matrix. Laminates 83 and 120 mm wide are supplied in rolls of 11 linear m; before installation the protective film is removed from both sides and they are bonded to the prepared substrate with CarbonWrap Resin Laminate+ adhesive. This is an element of the CarbonWrap external reinforcement system for industrial buildings, bridges, columns and beams; the tensile strength is more than 1100 MPa, the modulus of elasticity more than 150 GPa.
| Manufacturer | CarbonWrap — OOO “Nanotekhnologicheskiy tsentr kompozitov”, Moscow |
|---|---|
| Type | composite strengthening |
| Use | industrial buildings, bridges and overpasses, columns and beams |
| Base | plate of high-strength carbon fibres in a polyurethane matrix (polyurethane pultrusion) |
| Packaging | width 83 or 120 mm, rolls of 11 linear m |
| Application method | substrate sound, prepared by abrasive methods, free of defects, protrusions and voids, dust-free, dry; lay the laminates out on a clean table, remove the protective film from both sides; the laminate is placed within the pot life of the adhesive and pressed on with a rubber roller, excess adhesive is removed |
| Key properties | fibre type — high-strength carbon; polyurethane matrix; fibre volume content > 65 %; tensile strength > 1100 MPa; modulus of elasticity > 150 GPa; cross-section 550 mm2 (data sheet for size T-50/110) |
| Shelf life | 1 year from the date of manufacture; in closed packaging, in a dry room at +5…+25 °C |
| Standards | TU 22.21.42-044-38276489-2017 (TU 2256-044-38276489-2017) |
Data from the manufacturer’s technical data sheet. The coating system, number of coats and quantity are selected for your project on request.
Epoxy putty for levelling the substrate and repairing small defects and cracks before installing CarbonWrap at temperatures from +10 °C.
Epoxy adhesive paste for bonding CFRP laminates and steel plates, levelling the substrate and repairing cracks; 30 kg kit.
Carbon grid with a 10 × 20 mm mesh for strengthening structures in mineral repair mortar: bridges, tunnels, tanks, columns.
Bidirectional carbon fabric of 6K yarn for repair and seismic retrofitting of reinforced concrete, masonry and reinforced masonry, and steel structures.
Bidirectional carbon fabric of 12K yarn for strengthening structures of complex shape and in confined conditions; roll width 1200 mm.
Unidirectional carbon tape 300 mm wide for external reinforcement of columns, beams and other structures with CarbonWrap Resin saturating resin.